- The Mapping Resource
- Automatic Retries
- Canary Releases
- Circuit Breakers
- Cross-Origin Resource Sharing
- Method-based Routing
- Prefix Regex
- Traffic Shadowing
- Developer Portal
- Edge Policy Console
- The Ambassador Module
- Gzip Compression
- Host CRD, ACME Support, and External Load Balancer Configuration
- Ingress Controller
- Troubleshooting Ambassador
- Custom Filters
- Deploying to Kubernetes from GitHub
- Knative Serverless Framework
- Prometheus monitoring
- Frequently Asked Questions
Since Ambassador Edge Stack's configuration is entirely stored in Kubernetes resources, no special process is necessary to upgrade Ambassador Edge Stack.
The steps to upgrade depend on the method that was used to install Ambassador Edge Stack, as indicated below.
- If you installed using the Operator, then you'll need to use the Operator to perform the upgrade. To verify whether the Operator was used to install Ambassador Edge Stack, run the following command to see if it returns resources:
$ kubectl get deployment -n ambassador -l 'app.kubernetes.io/name=ambassador,app.kubernetes.io/managed-by in (amb-oper,amb-oper-manifest,amb-oper-helm,amb-oper-azure)'NAME READY UP-TO-DATE AVAILABLE AGEambassador 1/1 1 1 ...
- If you installed using the Helm chart or
edgectl install, then you should upgrade with the help of Helm. To verify this, run the following command to see if it returns resources:
$ kubectl get deployment -n ambassador -l 'app.kubernetes.io/name=ambassador'NAME READY UP-TO-DATE AVAILABLE AGEambassador 1/1 1 1 ...
- Finally, if you installed using manifests, simply run the commands in the following section. To verify whether manifests were used to install Ambassador Edge Stack, run the following command to see if it returns resources:
$ kubectl get deployment -n ambassador -l 'product=aes'NAME READY UP-TO-DATE AVAILABLE AGEambassador 1/1 1 1 ...
If none of the commands above return resources, you probably have an old installation and you should follow the instructions for upgrading to Ambassador Edge Stack.
If you're using the YAML files supplied by Datawire, you'll be able to upgrade simply by repeating
kubectl apply command:
kubectl apply -f https://www.getambassador.io/yaml/aes-crds.yamlkubectl apply -f https://www.getambassador.io/yaml/aes.yaml
This will trigger a rolling upgrade of Ambassador Edge Stack.
If you're using your own YAML, check the Datawire YAML to be sure of other changes, but at minimum,
you'll need to change the pulled
image for the Ambassador Edge Stack container and redeploy.